In this year’s Tools & Shops issue (FWW #223), Chris Gochnour built a great-looking tool cabinet for his hand tools. The piece looks like a million bucks, yet it was built with simple materials and joinery.

To make the most of the space, Gochnour made a few tool holders for chisels, scrapers, files, spokeshaves, squares, and the like. We didn’t have enough space talk about them in the magazine, but we’ll take you through the process here.

The holders are clever and simple to make and can be adapted to any cabinet—you could even use them to hold tools on a wall.

Here’s how Gochnour made them:




Chisel Holder

tool cabinet

click to enlarge


The door-mounted chisel holder takes advantage of what’s typically unused space. It’s easy to make using a tablesaw and drill press. Cut the blank to size and then lay out the slots and holes for the chisels.

tool cabinet

click to enlarge


For clean results, drill the holes on the drill press using a Forstner bit. The hole diameters are based on the chisel handles (designs vary).

tool cabinet

click to enlarge


Cut the slots at the front of the holder using a tablesaw and miter gauge. You can use a dado set for the job, but it’s faster to use a combo blade and nibble away at the waste.

Once the slots and holes are done, drill holes for the mounting screws and then bevel the back of the holder slightly (about 10 deg.). The bevel allows the tips of the chisels to point inward, which makes it a little easier to grab the handles of the chisels. After some sanding, the holder is ready for finish and mounting.

chisels plan

click to enlarge

 



Spokeshave Holder

tool cabinet

click to enlarge


Spokeshaves are hard to hold because of their design, and designs vary greatly, especially among the wood shaves. Gochnour’s two-post design will hold any type. This holder is made using a tablesaw, a drill press, and a bandsaw. Cut the blank to thickness and width, leaving it long for now, and then lay out the angled slots.

tool cabinet

click to enlarge


Drill the base of each slot on a drill press using a Forstner bit.

tool cabinet

click to enlarge


Use a bandsaw to remove the waste. Adjust the miter gauge to the appropriate angle and cut to the lines. Clean up the slots with files and sandpaper.

tool cabinet

click to enlarge


Cut the blank to length, and then rip it in half.

Now sand, finish, and mount the holders. Be sure you don’t space them too far apart.

chisels plan

click to enlarge



 



Square Holder

tool cabinet

click to enlarge


The square holder is the easiest of the bunch to make using just the tablesaw. Cut the blank to thickness and width, but leave it long until all the slots have been cut.

tool cabinet

click to enlarge


Lay out the slots and cut them on the tablesaw. After, cut the holder to length, then sand it, finish it, and mount it.

chisels plan

click to enlarge

 



File and Scraper Holder

 

tool cabinet

click to enlarge


This holder requires angled slots of two different sizes: narrow for the scrapers, wider for the files. All cuts are made on the tablesaw with the blade angled 10 deg. Cut the blank to thickness and width, but leave it long until all the slots have been cut. Then lay out the slot locations.

 

tool cabinet

click to enlarge


First cut the angled slots for the scrapers using a combination blade. Then, without changing the angle, switch to a 1/4-in. dado set to cut the slots for the files.

After, cut the holder to length, then sand it, finish it, and mount it.

chisels plan

click to enlarge


GET THE FULL-SIZE PLANS

Digital plans, a cutlist, and a SketchUp drawing for this project are available in the Fine Woodworking store.

BUY NOW

Woodworking Plans