How to Install a Bandsaw Fence

Q:

Based on Asa Christiana’s recommendations (“Bandsaw Fences,” FWW #230, p. 55), I bought the Grizzly resaw bandsaw fence. However, I am not clear on how to set the fence’s cursor because the fence can be set up three different ways. Also, should I put the fence on the right or left side of the blade?

Ike Weatherholtz, Falling Waters, WV

A:

Most woodworkers use the fence on the left side of the blade, because it gives unlimited room out to the right for a large workpiece.

Set the cursor with the aluminum fence in the tall position. That’s how you’ll use it most often.

Start by setting up the blade and guides. Then square the table to the blade. Bring the fence lightly against the blade’s teeth. Finally, align the fence’s cursor with the “0” on the tape.

Attach the fence in the “tall” position. Slide it over to the blade, so that it just barely touches the teeth (left). Now align the cursor to the scale’s “0.” Simply loosen the screws and move the cursor, which has oversize holes for the screws, right or left. – FWW Staff

Fine Woodworking Recommended Products

Stanley Powerlock 16-ft. tape measure

With its smooth lock, tough case, compact size, and excellent accuracy, this Stanley tape is perfect for workshop use.

Buy at Amazon

Rockler Deluxe Panel Clamp

These clamps can handle glue-ups between 10 in. and 36 in. wide, and boards up to 3 in. thick. Sliding feet attach to the lower bars with magnets, letting you position them quickly for stability on any surface. The spring-loaded jaws adjust easily, dropping into notches along the bars. And the powerful clamp handles clear the benchtop.

Buy at Amazon

Double Sided Tape

A thin woven core makes XFasten tape strong yet not too thick (0.008 in.), and helps it hold powerfully without being difficult to peel off.

Buy at Amazon