Grizzly Industrial - Grizzly – Forstner Bits
Grizzly's Forstner bits were named best value in a Fine Woodworking tool testA Forstner bit is the best way to bore high-quality holes that are accurately sized, accurately located, and with a cleanly cut rim. Today, the bits come in a variety of designs. To find out which ones are best, I tested 18 brands judging them by several criteria: Size, chip-clearing, temperature, and drilling ability.
Size – I tested 1/2-in.-dia. and 1-in.-dia. bits. I measured the diameter of each bit to see how close it was to the specified size, and then I measured the diameter of the hole itself. Most holes were slightly larger than the bit that drilled them, indicating slight runout. For the Grizzly bits, the 1/2-in.-dia. bit was exact, 0.500-in.-dia., and the 1-in.-dia. bit was 1.002-in.-dia. The bits drilled holes that were 0.500-in.-dia. and 1.003-in.-dia. respectively.
Chip Clearing – Bits choked with chips don’t cut well and may increase friction and burning. Many of the 1/2-in.-dia. bits became badly plugged when the head went below the wood’s surface. The Grizzly bits, however, didn’t get plugged. The 1/2-and 1-in.-dia. bits both cleared chips.
Temperature – To test the longevity of the bits, I mounted each 1-in.-dia. bit in a drill press. I chose the larger bits for this test because there is a greater area in contact with the wood, and therefore more friction. I set the speed to 480 rpm and drilled 100 holes 1 in. deep in hickory, a wood known for its ability to dull a sharp cutter. I used a digital infrared thermometer to check each bit’s temperature every 10 bores. An increase in temperature could signal a dulling cutting edge. While the temperatures ranged from 134ºF to 268ºF, the Grizzly bit measured an average of 174°F. In general, bits that made cleaner cuts generated less heat.
Drilling Ability – No other type of bit can match the quality of a Forstner for the cut around the rim and sides of a hole. The Grizzly 1-in.-dia. bit left a bore rim with good quality, while the 1/2-in. bit was of very good quality.
I also tested to see how the 1/2-in. bit cut overlapping holes and holes drilled at an angle. The rim design in Forstner bits allow you to drill clean overlapping holes, as when excavating a mortise. The Grizzly bits showed scored a “very good” in their ability to bore overlapping holes. The Forstner bit’s sharp rim also makes it easy to start the bit in a steeply angled workpiece, as when cutting pocket holes in a table apron. The Grizzly bits received an excellent score when tested for this.
Overall, I picked Grizzly for best value while Famag bits were named the best overall.
Fine Woodworking Recommended Products
Stanley Powerlock 16-ft. tape measure
Makita SP6000J1 Track Saw
Ridgid EB4424 Oscillating Spindle/Belt Sander
Log in or create an account to post a comment.
Sign up Log in