A 6-in. jointer is a good starter size for a workshop, so I chose 11 models to examine, all of which happened to be made in either Taiwan or the People’s Republic of China. The only significant differences among them were in the fence designs and the mechanisms by which you raise and lower the infeed and outfeed tables.

With a jointer, you want infeed and outfeed tables that are flat and coplanar to each other, meaning that the tables should run parallel from one end of the machine to the other.  To function properly, the surface of the outfeed table must be flush with the top arc of the knife cut and perfectly parallel to the full width of the knife cut as well as to the surface of the infeed table.

Among these machines, you can choose from four fence designs, my favorite of which is the rack-and-pinion, because adjustments are quick and easy to make, and you can move the fence in and out with one hand.

This machine was easy to put together, but the photos in the instruction manual were of a different model with an open stand. The fence on this machine is different from all the others: It consists of a hexagonal bar held captive in pillow blocks with two Allen screws and a threaded handle. The gib screws were adjusted well at the factory, making it easy to raise and lower both the infeed and outfeed tables.

Fine Woodworking Recommended Products

Oneida’s Super Cell Dust Collector

30-Gal with Wall Mount

Buy at Amazon

Veritas Precision Square

This precision square is incredibly versatile, from checking squareness to dialing in machine setups.

Buy at Lee Valley

Rikon 10-3061 10-in. Deluxe Bandsaw

The 1⁄2-hp motor has all the power needed to resaw at its maximum capacity of 5 in.

The saw has two speeds: 3,280 sfpm (surface feet per minute) for wood and 1,515 sfpm for soft metals and some plastics.

Buy at Amazon