I’ve tryed everything I can think of and still am
unable to find a successful way to line up a 3/4″
dado on a wide board that I must cut from opposite sides.
I made a special fence to accomodate the stacked blades,
measured carefully and still have not aligned the cuts
exactly. Any suggestions will be greatly appreciated.
Ken
Replies
rip the board, plow the dados, glue up with a scrap in the dado for alignment.
or , door no.2 set up as a out rip, not a crosscut.
or, door no.3 a router.
Thanks! Great idea. Wish I'd thought of it.
I actually ended up using a straight edge on the
first dado to align the second and it worked out
well. I think your idea would have been easier
This forum post is now archived. Commenting has been disabled