Replies

1. 
   shauntiago | Jan 15, 2009 02:15am | #1

   Thanks for the info but, the one you mentioned fits a bunch of the smaller routers and not the 3 1/2 hp model. Thank-you for answering
   S.Harrison

1. 
   JerryPacMan | Jan 15, 2009 05:56pm | #2

   Sorry for the bad information, shame on me.  Since it was the guide I received with the router I assumed it would work.  The problem is that the router has always been in the router table and I never used the guide.  I braved the cold,  -7 here, went out to the workshop and found that the rod spacing and rods are for the smaller routers.  You need 1/2" rods and rods center spacing of 5 1/8".  Have you tried to contact Milwaukee? 

   http://www.milwaukeetool.com/us/en/site.nsf/frmContactUs?OpenForm&nav1=cu

     

   Life is what happens to you when you're making other plans.

   "Life is not a success only journey."  Dr. Phil

1. 
   shauntiago | Jan 15, 2009 09:30pm | #3

   Yes I have contacted them several times and they finally told me of several Porter Cable Guides that would work. However, I had already figured that out by the time they got back to me.
   Once again, thank-you for you input, it is much appreciated.
   S. Harrison