Carving - Page 3 of 15

Carving 300-lb. Poles

January 31, 2018

It's rare, but sometimes a carving job requires a bucket truck
Hone gouges with a dowel, sandpaper, and a drill

January 22, 2018

Here is a simple but effective shopmade tool for honing carving gouges, taking the place of slip stones and other expensive gear
Ep 13: Food-Safe Finishes for Greenwood Pieces

January 18, 2018

In the final episode, Dave discusses food-safe finishing options for your bowl
Ep 12b: Carving the necklace – part 2

January 4, 2018

In this episode, Dave carves the decorative necklace with a carving chisel and gouges
Ep 12a: Carving the necklace – part 1

January 4, 2018

In this episode, Dave lays out the necklace carving for the bowl handles
Ep 11: Finishing cuts on the outside of the bowl

December 21, 2017

In this episode, Dave finishes the outside surface of the bowl with a drawknife and carving chisel
Ep 10: Finishing cuts on the inside of the bowl

December 14, 2017

After drying the bowl, Dave flattens the bottom and gets to work texturing and finishing the inside of the bowl with gouges
Ep 9b: Refining the outside of the bowl – Part 2

December 7, 2017

In this episode, Dave finishes the refinements to the outside of the bowl with a bent gouge, carving chisel, and sloyd knife before leaving the bowl to dry
Ep 9a: Refining the outside of the bowl – Part 1

December 7, 2017

In this episode, Dave begins to sculpt the outside of the bowl using a drawknife and ax
Ep 6: Hollowing out the bowl with an adze

November 16, 2017

In this episode, after a safety talk, Dave uses the adze to hollow out the bowl, bringing to light what will be the finished surface

No results found.