Fine Woodworking

Barry NM Dima

Tiny Bit of Wood for a whole lot of people

March 26, 2021

Opening an affordable school where woodworking is therapy, and the marginalized are centered.
Tool review: Infinity router bit vise

March 9, 2021

This two-sided vise holds a bit's shank securely against rotational forces when you remove or replace a bearing.
Robell Awake: Crafting change

February 2, 2021

Robell works to bridge woodworking’s opportunity gap and challenge the scope of “period” and “fine” furniture.
New tools to look out for this winter

December 22, 2020

Festool edge sanding guide, The Anarchist's Workbench, and Veritas 4-in. Carver's model drawknife.
Video: Watch Peter Follansbee carve a shallow relief pattern

December 17, 2020

You didn't get to visit Peter's shop with Barry and watch him carve in person, but this is almost as good. Plus you can wear your pajamas.
New woodworking tools to look out for this fall

November 2, 2020

Festool STM 1800 Mobile Sawing Table; Hedgehog Featherboard HH-30; JWS-10 variable speed wet sharpener by Jet.
Tool Review: ISOtunes Free Bluetooth Hearing Protection

August 7, 2020

Barry Dima takes a look at (and a listen to) Isotunes' new truly wireless bluetooth earbuds.
Toolbox show and tell – Hammers and mallets

May 21, 2020

Four FWW staffers show off their favorite whacking implements in their toolboxes.
What you don’t see in our photos

May 6, 2020

The moments where our authors stop and slow down have been some of the most educational for associate editor Barry NM Dima.
Versatile Bench Design

November 1, 2019

The Center for Furniture Craftsmanship uses this workbench design as the basis for a router table, a drafting table, a sanding station, and more.

No results found.