Video

Ep 8: Desktop Tongue and Edge Profile

August 20, 2019

In this episode, Tim adds a tenon to the desktop with a tool most often found in pro shops, the shaper
Ep 7: Mortising The Legs For Stetchers

August 13, 2019

In this episode, Tim creates the stretchers that connect the two side assemblies
STL195.5: Scott Landis of Greenwood Global

August 9, 2019

For more than 25 years GreenWood has worked with artisans in Honduras and the Peruvian Amazon to produce high-quality wood products from well-managed forests
Video: Michael Fortune’s Design Process

August 7, 2019

In this video, Michael takes you through his design process step by step, sharing his tips for drawing and brainstorming along the way
Ep 6: Tapering and Shaping the Legs

August 6, 2019

In this episode, Tim Rousseau heads over to the tablesaw to taper the legs. Then, it's back to more pattern routing
Bookcase Project: Introduction – Start Woodworking S2

August 5, 2019
How To Rip Lumber Safely on the Tablesaw – Start Woodworking S2:Ep2

August 5, 2019

In this episode of Getting Started in Woodworking, we demonstrate how to safely rip lumber on the tablesaw. You'll learn how to set up a tablesaw for basic rip cuts, and how…
An Insider’s Guide to Buying Hardwood Lumber– Start Woodworking S2:Ep1

August 5, 2019

In this episode of Getting Started in Woodworking, we take a trip to a few local lumberyards to show you some insider tips for purchasing the best hardwood and softwood lumber for your woodworking…
How To Crosscut Lumber on the Tablesaw – Start Woodworking S2:Ep3

August 5, 2019

In this episode of Getting Started in Woodworking, the third in our series on building an oak bookcase, we demonstrate how to safely crosscut lumber on the tablesaw. Crosscutting lumber…
STL195: New Tools From AWFS in Vegas

August 2, 2019

Rollie Johnson and Justin Fink join Tom, Barry, and Ben to discuss new tools being shown at the AWFS fair in Las Vegas

No results found.