Grape vine I mean. I’ve searched all my usual sources, eBay, Google and Yahoo, and the archive here, but I can’t find anything. I don’t need much; just enough to make four 1.5″ balls. Either the raw vine or a prepared turning block will do.
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free TrialCategories
Discussion Forum
Digital Plans Library
Member exclusive! – Plans for everyone – from beginners to experts – right at your fingertips.
Highlights
-
Shape Your Skills
when you sign up for our emails
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply. -
Shop Talk Live Podcast -
Our favorite articles and videos -
E-Learning Courses from Fine Woodworking
-
-
Replies
Plenty of Concord grape vines growing wild around here, I could go out and get you some.
C.
Thanks. I may take you up on that if I can't get it anywhere else. I think the piece would have to be about 5" thick and a foot long raw. Is there anything like that in your woods?
5" diameter may be hard to find but 3" for sure, length is not a problem, I will double check tomorrow on my daily walk.
Where are you ?C.
I'm in New York. Three inches might do it.
NY 's not too far send me an e-mail.C.
This forum post is now archived. Commenting has been disabled