I am just getting back into woodworking after a 5+ yr hiatus. I had sold all of my stationary equipment (General TS, DJ20 rtr, Delta13″ planer, etc…)Anyway I recently purchased a MM 300 Smart combonation machine and a MM 16″ BS. Very nice stuff….So I have been looking for a router table and decided after looking at a gazillon threads on many boards to purchase the Veritas Router table, fence, hold downs, stops, etc. etc) along with a M12V Hitachi router. I have not received any of the equipment yet, probably in a week or so but will be looking fwd to putting it to work right away. I had built my own rtr table about 10+ years ago from a plan out of Wood magazine with a Ryobi 600E (?) rtr. It was a pretty nice set-up but nothing compared to the Veritas set up.
Jim
Replies
Jim I have the rotour table, fence and sliding t fence, and love it.The only thing that i noticed last week was that one of the clamps that hold the rotour in place came loose. Don't know if i didn't tighten enough or it is something to check often . will keep an eye on it as a 3 hp router dropping out at speed is scarey enough. good luck.
Jim, I think you'll like the Veritas set-up. I have the table, and love it. Be sure and let us know how you like it after a couple hundred miles or so!
forestgirl -- you can take the girl out of the forest, but you can't take the forest out of the girl ;-)
Another proud member of the "I Rocked With ToolDoc Club" .... :>)
This forum post is now archived. Commenting has been disabled