Does anyone have a good suggestion for a machine where you can feed boards and have it round over 2 edges at once? I am taking half inch thick sheets and rounding them in large qtys.
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free Trial
Replies
Traditionally that was done on a double end tenonner but nowadays, CNC will do just about everything to a panel reducing handling from one machine to the next.
Try this:
https://www.whitesiderouterbits.com/collections/double-roundover
I have seen it done using a shaper with a bullnose cutter.
If it's a really big job, you could even install a power feeder on the shaper.
Mike
There are bullnose router bits too.