Can anyone in this highly skilled an helpful group educate me or direct me to an online how to page for setting up a two flute drawer glue joint.
I recently bought a Whiteside for stock 5/8″ and greater. I spent about 3 hours grinding up scrap stock and finally came away with a respectable looking joint of a 3/4 birch front to a 1/2 baltic birch ply side. I am not sure I could repeat the steps without more trial and error, and would really just like to know the right approach to zeroing in.
All comments, advice or other wise are appreciated.
ADD47
Replies
Once you get a setup that works, make a setup guage with some scrap and write on it with a red sharpie what it is for. Only have to do the trial and error thing once that way.
Tom
Douglasville, GA
This forum post is now archived. Commenting has been disabled