excalibur sliding table

gizzo | Posted in Power Tools and Machinery on June 24, 2004 01:22am

I just set up the sliding table from sommerville design and I am only getting 40″

with the fence in the back position instead of the 49″ , with the fence in the front

position I’m getting 28″. Has anyone had this happen?

thanks for your help.

Barrie2777 | Jun 25, 2004 01:35am | #1
I have had an Excalibur fence for ten years so my model may vary slightly from yours. However my dimensions are 27-1/2" in front and 51" with the fence moved to the rear position. Since our front dimensions ar esimilar, I would guess that your setup is hitting a bracket of something else which is preventing full travel.

This forum post is now archived. Commenting has been disabled

Get It All!

UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.

Discussion Forum