Hole saws work well in a variety of woods, but they tend to clog quickly, stop cutting, and start heating up. Instead of forcing them downward through the cut, drill down to the depth of the teeth and retract the saw. Then, without shutting off the drill press, you can unclog the teeth by pressing a wire or stiff nylon brush against the side of the saw that’s spinning away from you. Now drill a little deeper and repeat the process, until you have drilled through the workpiece. Drilling will go faster this way, without burning, and the plug will be easier to remove as well.

—DAN MARTIN, Galena, Ohio
Drawings: Dan Thornton
From Fine Woodworking #310.

Fine Woodworking Recommended Products

Veritas Precision Square

This precision square is incredibly versatile, from checking squareness to dialing in machine setups.

Buy at Lee Valley

Rikon 10-3061 10-in. Deluxe Bandsaw

The 1⁄2-hp motor has all the power needed to resaw at its maximum capacity of 5 in.

The saw has two speeds: 3,280 sfpm (surface feet per minute) for wood and 1,515 sfpm for soft metals and some plastics.

Buy at Amazon

Grizzly G0495X Industrial Helical Cutterhead 8-in. Jointer

Regardless of the board’s grain, this jointer produced excellent results. Its fence was totally flat, worked smoothly, and locked well, staying in place even after jointing multiple edges. Getting the fence to 90° was very easy, but the 90° stop was a little tricky to set and the fence did not go back to square when using it. For those who would use it, there is also a digital depth-of-cut scale.

Buy at Amazon