Shop Tips
Quick Tapers on the Table Saw
Oct 25, 2005
Here’s a quick and foolproof way to cut tapers. First draw the desired cut line on the workpiece in pencil. Set the saw fence to a width slightly greater than the workpiece, and cut a scrap of hardboard to this width. Using either double-faced tape or tacks, affix the hardboard to the workpiece, carefully aligning the edge of the hardboard to the pencil line. Run this assembly through the saw without resetting the fence.
The saw will cut a precise taper, right to the line.
Leigh Jerrard, Los Angeles, Calif.
Fine Woodworking Magazine, February 1997 No. 122
Fine Woodworking Recommended Products
Rockler Deluxe Panel Clamp
These clamps can handle glue-ups between 10 in. and 36 in. wide, and boards up to 3 in. thick. Sliding feet attach to the lower bars with magnets, letting you position them quickly for stability on any surface. The spring-loaded jaws adjust easily, dropping into notches along the bars. And the powerful clamp handles clear the benchtop.
Bessey K-Body Parallel-Jaw Clamp
The 3 3/4" deep parallel jaws allow for all types of clamping, from thin panels to joinery.
Veritas Wheel Marking Gauge
A wheel-type gauge is the easiest to use, and this wonderful Veritas model is a steal at $38.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
Log in or create an account to post a comment.
Sign up Log in