My first big project; perhaps too ambitious, but I want to try it. I purchased plans for a Morris chair from FWW. The instructions tell me to use 1/8 inch veneer around a core for the front and back legs. That means a miter joint longways on each of the sides of the veneer? That’s how I picture it, but how do I cut a miter joint that will match all the way up and down a twenty some inch leg on 1/8 inch material? I believe I can cut the veneer; it may end up a little more than 1/8, I can make up for the width by changing the dimmension of the core. It will be as close to 1/8 as I can make it. I have a bandsaw, jointer and planer.