My electric hammer after receiving electricity produces abnormal cry and turn slowly, I want to know is why?
I’ve been using the electric hammer for a long time. I don’t want to throw it away. Can I fix it
Fine Woodworking Recommended Products
Chicago Electric Belt Sander
Weight: 7 lb. Amps: 6 Variable speed: Yes Belt alignment: Good Material removal rate: Fair Sanding flatness: Very good Shaping/scribing: Good Handling on side: Very good Dust collection with hose: N/A
Pfeil "Swiss Made" Gouge #3 Sweep - 14mm
•Electronically hardened alloy chrome-vanadium steel blade •European hardwood octagonal square tang handle •14mm #3 sweep gouge
Suizan Japanese Pull Saw
A versatile saw that can be used for anything from kumiko to dovetails. Mike Pekovich recommends them as a woodworker's first handsaw.
Crown Rosewood and Brass Cutting Gauge
The Crown Tools cutting gauge tightens securely and cuts well, but fit and finish issues make fence adjustments fussy. The thumbscrew can’t apply moderate tension, which would make adjustment easier.
Makita LS1219L Miter Saw
This is the saw I want in my shop. For one, it’s easy to use. All of the controls are easy to reach and manipulate, and the glide mechanism is both robust and smooth. The handle works well for righties and lefties. Then there are added bonuses that no other saw has. For instance, its hold-down is superb, as it can move to different locations, hinges for a greater range of coverage, and actually holds down the work. In addition, the saw has two points of dust collection, letting it firmly beat the rest of the field. The one downside was the saw’s laser, which was so faint we had to turn off the shop lights to see it. Still, all these pluses in a package that fits tight to the wall? That’s a winner for me.
Replies
1. Burnt switch contact.
2. The mechanical part is stuck or the dynamic part is rubbed together.
3. The drill bit bit or touches the steel bar.
4, special nut loose.
5. A small amount of short circuit or open circuit in the armature.
6. Chips get stuck when drilling deep holes.
7. Low power supply.
This forum post is now archived. Commenting has been disabled