I just put the wings on my Jet Cabinet Saw. I checked the flatness of the top and I could not get a .005 feeler gauge thru anywhere but right around the blade. Around the blade general area .008 would not go under my straight edge. I used a 36″ starret straight edge to check this. I checked across the top in several places and from corner to corner. Are these acceptable? Seems pretty good to me but just checking. Thanks for your info. RICK
Discussion Forum
Get It All!
UNLIMITED Membership is like taking a master class in woodworking for less than $10 a month.
Start Your Free TrialCategories
Discussion Forum
Digital Plans Library
Member exclusive! – Plans for everyone – from beginners to experts – right at your fingertips.
Highlights
-
Shape Your Skills
when you sign up for our emails
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply. -
Shop Talk Live Podcast -
Our favorite articles and videos -
E-Learning Courses from Fine Woodworking
-
-
Replies
This subject was just mentioned a short time ago. It's been my experience that most manufacturers allow .015" on a tablesaw so you are in good shape
Rick
Grab some wood and go rip. You're good to go!
The NASA boys would get an ulcer trying to get it much flatter!
:>)
sarge..jt
Proud member of the : "I Rocked With ToolDoc Club" .... :>)
Thanks Rick and Sarge. I had read some of the old post but a lot of numbers were being thrown around and I just wanted to make sure I was OK. Rick
This forum post is now archived. Commenting has been disabled