I need to make a few kitchen cabinet doors. A lot of articles that I have read indicate that a stacked rail and stile bit is the way to go from a cost standpoint if the bit won’t get a lot of use.
MLCS has stacked rail and stile bits but I haven’t seen any reviews or comments.
Anybody have any experience with this product or other manufacture’s stacked bit that you would recommend?
Thank You
Replies
I have a stacked set that I bought so long ago, I'm not sure where I bought it. Eagle America I think. I think it's better than two separate bits because you don't have to remove it from the router to change cuts. I just lock the shaft and use a combination wrench to take te stack apart. Mine has made a lot of doors and is still working like a champ.
This forum post is now archived. Commenting has been disabled