Replies

1. 
   RickL | Jun 27, 2006 03:20pm | #1

   The better stocked hardware stores carry National, Stanley brackets etc and they do make some smaller ones. Ask to look in the catalog to see what else is available. On the other hand you can cut something down or buy some angle aluminum or steel and cut and drill exctly what you want.

   Or go to page 2866 in http://www.mcmaster.com

1. 
   edwardh1 | Jun 27, 2006 05:53pm | #2

   Thanks- those are still too big. looking for 3/4 inch or so

1. 
   RickL | Jun 27, 2006 06:12pm | #3

   Buy some 3/4 angle and make your own or take some of the small straight mending plates and bend them up. It's so simple. Until you find a commercial source just wing it. Aluminum and brass will cut on a table saw. Steel can be cut many different inexpensive ways.