Hello all,

Never posted here but have read much.  So, I want to throw something out for some feed back.  I have been doing some cabinet work on a boat.  I’m getting ready to build a table that will have two rounded corners ( 6 inch radius).  The table will have a 2 inch fiddle around all four sides. How about some ideas on turning the corners, I don’t want to see end grain. The thickness of the fiddle is going to be 5/8″.  Do I try the steaming method or laminating thin (1/8″) pieces until I reach the desired thickness?  Thanks for any input !

P. Powell

buildit4you