I see a lot of questions but I don’t see a lot of answers. Am I looking in the wrong place?
Fine Woodworking Recommended Products
Sander Pad for Dewalt, 2 Pack
5 inch Replacement Orbital Sander pad has 4 screw holes and 8 dust holes.
Double Sided Tape
A thin woven core makes XFasten tape strong yet not too thick (0.008 in.), and helps it hold powerfully without being difficult to peel off.
Black & Decker Dragster, DS321 Belt Sander
Weight: 6.5 lb. Amps: 7 Variable speed: No Belt alignment: Poor Material removal rate: Poor Sanding flatness: Very good Shaping/scribing: Good Handling on side: Very good Dust collection with hose: N/A
Delta 26‑2251 Miter Saw
The Delta was another model that you can locate close to a wall. It employs dual articulating arms that save space while yielding good, wide cuts provided you use good technique. The saw is tied for the second-shortest overall footprint. The Delta’s ergonomics were a treat too. Thanks to convenient placement and ease of use, the locks for the miter and bevel stops were superb. Its LED results in a nice, accurate shadow. The dust collection was just slightly lower than the Makita’s, but still quality for a miter saw.
Metabo HPT C12RSH2 Miter Saw
This saw has a similar design to the best overall Makita, but it falls short because of small details that add up. First and foremost are the poor ergonomics. I find vertical handles cumbersome. The bevel lock was frustrating too. The tilt lever was at the back of the saw, meaning the tool can’t sit tight to the wall. There are no bevel detents. It’s the only saw without a flip stop, meaning you have to reset it between cuts. Still, the saw has a compact design, and it’s the most affordable of the bunch. The side extension arms have slick levelers, too.
Replies
You're in the right place, but I haven't.
I've been tied up traveling, out of reach of the internet, and then had to spend a few days recovering from some bug I caught in my journeys. I'm sorry for the delay, I'll get my questions caught up over the next couple of days.
John White
This forum post is now archived. Commenting has been disabled