Has anybody used this tail vise from LV?
http://www.leevalley.com/wood/page.aspx?c=2&p=31136&cat=1,41659
It looks like it should work well, but I would welcome opinions. I’m also looking for the dimension of the overall height. I know from the ad that the overall length is 15″ and the width of the sliding rails is 2″. I’m thinking about a retro-fit to my existing bench.
Thanks,
-Chuck
Replies
Give Lee Valley a call on Monday and ask for technical. Then you will know the height and if it will fit.
Regards...
Sarge..
No kidding? I guess I should have known that they would have such a service. I'll give them a call - thanks for the tip.
-Chuck
Even if they don't know from their manuscript, I would ask them to go measure one at their convenience and either e-mail or call you back. I can't imagine from their reputation that they wouldn't do that.
I called DeWalt tech once to find out what size machine screw held the base plated on a DW 621 router. You could hear the young lady thumbing through pages and eventually she told me the info was just not available. Amazing to me as it was... I finally just went and mic'ed it and got a screw from the hardware store. I also sold the router and got a Milwaukee. ha.. ha... ha..ha..ha..
Good luck...
Sarge..
This forum post is now archived. Commenting has been disabled