Replies

1. 
   Kilroy | Oct 21, 2008 08:09am | #1

   Doesn't it just burn up and then rise again from the ashes in Pheonix?

1. 
   troys | Oct 21, 2008 08:29am | #3

   I think it becomes dust in Phoenix:)

2. 
   jazzlover | Oct 21, 2008 08:23am | #2

   You can try Woodworkers Source on Elliot just west of Kyrene or Timber Woodworking in Mesa.  Both carry a wide assortment of wood.  Good luck.

1. 
   troys | Oct 21, 2008 08:29am | #4

   ThanksTroy

3. 
   SteveSchoene | Oct 21, 2008 08:37am | #5

   Check out http://www.woodfinder.com .  It often pulls up sources that are hard to discover otherwise, like the small cabinetmaker who sells really prime hardwoods from his barn.  (Not AZ, just an example.)

    

1. 
   troys | Nov 07, 2008 09:28am | #9

   Good idea, Thanks

4. 
   rdasilva | Nov 05, 2008 11:13pm | #6

   Phoenix area:

   http://www.superiorhardwoods.com
   http://www.azhardwood.com
   http://www.spellmanhardwoods.com

   That should get you started.

   
   

   ---

   Edited 11/6/2008 1:47 pm ET by rdasilva

1. 
   troys | Nov 07, 2008 09:28am | #10

   Thanks

5. 
   cubswin08 | Nov 06, 2008 04:17am | #7

   Timber Woodworking on Southern in Mesa has an amazing selection and about the best prices in town.  There was a place in Chandler just south of the airport called Chandler Hardwoods, with really big selection and very low prices, but last time I was there they had lost their lease and were moving out on I-10 somewhere near Firebird Lake.  They used to be incredibly disorganized, but the new location is supposed to have more room with better display capability.  Keep looking until you find them; it will be worth your while.  Meanwhile, Timber is a close second if you don't mind sorting through lots of not so good lumber to find the pieces you're looking for.  Ask for Alex.

1. 
   troys | Nov 07, 2008 09:31am | #11

   Thanks

6. 
   billbarrand | Nov 06, 2008 04:22pm | #8

   Hey, Troy

   Try Lane Stanton Vance at 480-736-3999 and talk to Steve, I think you will be happy with the prices

1. 
   troys | Nov 07, 2008 09:32am | #12

   Thanks