Replies

1. 
   MikeHennessy | Jul 01, 2008 02:43pm | #1

   "How do you go about cutting the fence rail?"

   Well, that can happen when you're cutting down sheet goods with a circular saw and using the TS for a sawhorse, and you misjudge how far from the edge of the table your cut line is.

   Never happened to me of course. It was a friend of mine. Yeah, that's it! Some other guy.

   I'm just sayin' . . . .

   Mike Hennessy
   Pittsburgh, PA

1. 
   saschafer | Jul 01, 2008 03:55pm | #2

   And the worst part of it is, your friend did it on your saw. The dumb !@#$%.

   -Steve

    

1. 
   MikeHennessy | Jul 01, 2008 07:18pm | #4

   "And the worst part of it is, your friend did it on your saw. The dumb !@#$%."

   Yeah!

   Now that I think about it, I think I'll invite him over a few more times. Then I'll HAVE to get that new SawStop. ;-)

   Mike HennessyPittsburgh, PA

2. 
   Dave45 | Jul 01, 2008 04:04pm | #3

   The same guy has been in my shop twice over the past year.  The first time, he clipped a corner off of my workbench and on the second visit, he left a saw kerf in the wood jaws of a bench vise.

   At least the incompetent SOB hasn't dinged anything really important...................yet!! - lol

2. 
   Dave45 | Jul 01, 2008 08:30pm | #5

   I don't know, Winemane.  Some have suggested that I might be the culprit but I limit myself to one mistake a decade.  As of this morning, I all caught up until August 2142. - lol