Replies

1. 
   Segil | Oct 19, 2005 02:57pm | #1

   Zendo,

        Any way you can get the machine to complete the necessary operation safely, that's what you should do.  Fly with the eagles!

2. 
   Elcoholic | Oct 19, 2005 05:55pm | #2

   Yes, that's why they're called 16/32 or 22/44.  Some of them are prone to leaving a slight peak down the middle of the board because of deflection.

   John O'Connell - JKO Handcrafted Woodworking

   The more things change ...

   We trained hard, but it seemed that every time we were beginning to form up into teams, we would be reorganized.  I was to learn later in life that we tend to meet any new situation by reorganizing; and a wonderful method it can be for creating the illusion of progress while producing confusion, inefficiency, and demoralization.

   Petronious Arbiter, 210 BC

1. 
   zendo | Oct 19, 2005 06:41pm | #3

   Thank you.

   -zen

3. 
   WillGeorge | Oct 19, 2005 08:43pm | #4

   is it normal or bad practice to flip the material and sand in 2 passes so that you can double the width going through the machine?

   Dumb here but why the open end then?

   EDIT;; Sort of funnin ya OK?

   
   

   ---

   Edited 10/19/2005 1:44 pm by WillGeorge

1. 
   zendo | Oct 19, 2005 10:28pm | #5

   Well I didnt know if you tight guys over here might say that those machines are for amatuers.

   Im a field guy and new to this silver spoon shop stuff.

   Last week I needed 1 drawer front for a current project. I brought the stick of cherry with me, and it was at his convenience.  A local cabinetmaker charged me $75 for a 14 inch, one piece front.  I stood there for the 20 minutes it took him to make it.    I was hoping to get a relationship going with him to pass business, but I dont think Ill go back.

   -zen

    

1. 
   WillGeorge | Jan 07, 2010 10:26pm | #6

   EDIT;; Was Sort of funnin ya OK? What I posted.. I ment no harm,,,