Replies

1. 
   MikeInOhio | Sep 26, 2020 07:19pm | #1

   I own that same router and have been happy with it. I use it for all kinds of edge treatments on various hardwoods.

   And using a 1/4 inch upcut spiral bit I've even cut 3/4 inch deep mortises in oak. I did this in 3 passes to minimize strain on the tool and the bit.

   It's a very capable little router.

   Mike

2. 
   IrishBill_NY | Sep 26, 2020 07:31pm | #2

   Thanks, exactly what I wanted to know....can it be used in a router table?

3. 
   _MJ_ | Sep 26, 2020 07:43pm | #3

   No reason not to, with the same approach MIO mentions.

4. 
   IrishBill_NY | Sep 26, 2020 07:58pm | #4

   Ty.

5. 
   GeeDubBee | Sep 27, 2020 01:07am | #5

   I have a few with multiple bases. It is a worthwhile tool that really becomes usable in the plunge base. Just remember it’s a 1HP, 1/4 collet tool and you’ll be fine. Height adjustment on the fixed base was a wonder when it came out. Since then it has been out done by the competition.

   The plunge base takes care of this but, I would think it would be clumsy for table use. Too late now but, I did take advantage of clearance sales on them when the 1-1/4 HP version came out. I picked up two for what my first one cost quite a few years ago.

6. 
   stantheman | Sep 27, 2020 09:39am | #6

   This is the older model right. Newer one is 1.25 hp I think? I have three of the 1 hp I keep loaded with certain bits I use often. Two things that would make me hesitate about using it in a table. The clamping mechanism that holds the router motor to a certain height is finicky and sometimes slips under pressure. Second is that changing the bits is a PITA. You have to hold in a stop to keep the collet from spinning loose, sometimes you need three hands to do it. Just my experience.
   But the wood doesn't matter - cuts fine. Its the size and profile of the bit that are significant. If you edge trimming or using straight bits its fine.

7. 
   IrishBill_NY | Sep 27, 2020 11:32am | #7

   Thanks🤙