Hi all,
I built a window seat for my home. The ¾ oak veneer plywood lid developed a cup. It’s about 3/32 high in the middle. I tried putting a 5/4 X 1 ½ inch oak stiffener on the lid, it helped a little but it’s still cupped. Any suggestions on how I can flatten this thing out?
Thanks
Jay
Replies
Sounds to me like the bottom isn't sealed from moisture. I'd install some battens underneath and make sure all surfaces are sealed with the same finish as applied to the top.
Regards,
Bob @ Kidderville Acres
A Woodworkers mind should be the sharpest tool in the shop!
This forum post is now archived. Commenting has been disabled