I know this question may not be applicable for “fine woodworking”, but I tried the ‘breaktime” forum and received little response. I’ll apologize in advance to anyone offended.
I just picked up an “Atro Helen 90 C” Framing nailer. I’ve looked all over the web and can’t find this model referenced anywhere. Has anyone heard of this beast? Where can I find nails for it? The tool has a sticker on it that says it uses Round Head Strip Nails. I think it needs 28 degree nails but I need to confirm that. Does anyone have a manual for it?
Thanks
Les
Fine Woodworking Recommended Products
Diablo ‘SandNet’ 80 Grit Sanding Disc
Compared to other products, the SandNet 80 grit cuts slower. However, if you're working inside someone's home and need to start at this grit, you might want to trade speed for improved dust collection.
Tite-Mark Marking Gauge
These gauges can be easily and precisely adjusted with one hand, which allows you to set the tool while holding a ruler or workpiece in the other. The quality is exceptional, and all have sharp cutters that offer great visibility.
Delta 22-555 Planer
Knife changes on this planer were easy enough, except that you need an Allen wrench to open the dust cover and gain access to the knives, and it’s not the same size as the wrench used to loosen the screws that secure the knives. The 2-1/2-in.-dia. dust port can be reversed for use on either side of the machine. Two material rollers on top of the machine aid with transferring stock from the outfeed side back to the infeed side. Finally, there is no gauge that indicates how much material you’re about to remove, a convenience that three other planers also lack.
Metabo HPT SB8V2 Belt Sander
The Metabo offers is comfortable and easy to control in all positions, with unmatched sanding speed and effective dust collection.
Skilsaw SPT88-01 Miter Saw
This saw performs as well as the others, but its price and inconveniences make it hard to recommend. As far as the positives go, the handle is comfortable to grip. In use, its power switch works for both righties and lefties. However, other ergonomics are OK at best. It’s also another saw with the bevel lock at the back, meaning it’s a reach to get to. The tool has good bevel and miter range. It’s the only worm-drive saw, but I did not notice any difference in cut. The saw cannot sit flush to a wall.
Replies
I know the nailer you speak of. Used to repair them in a former life some 13 years ago. They were awful for parts back then so I wouldn't think it would be easier. Italian guns. I haven't seen a reference to one since then either and your post comes up. I'll do a little looking but I'd say move on to other brands. Old machines are one thing but guns are an entirely different matter to keep going. On old O-rings we wouuld account for wear with dental floss at times but tolerances are so critical at times with these things. They used to come in orange, grey and red. Don't miss working on those. Get a Hitachi or something! Certainly not something typically used to make furniture.
Rick,
Thanks for the feedback. The guy I bought the gun from, realized today that you can't get nails for this gun anymore, so he happily gave me my money back. I'll go back to good old fashion hammer and nails for now.
Les
This forum post is now archived. Commenting has been disabled