After many years of MDF and 2×4 benches, I started into construction on the FWW Not-so-big Workbench. Downloaded plans from webstore and I purchased some new lumber to get thngs started. The base is red oak. This was also a great excuse to go out and get a 3/4 inch Robert Sorby mortise chisel.
Base is complete – now time to work on the top.
Fine Woodworking Recommended Products
Rikon 60‑101
The Rikon’s power and capacity are comparable to the other smaller models, but a few issues held it back. Because the chip bag hangs a bit loosely on the canister, it tends to slip off during changes. On the plus side, it’s the only small collector with a 5-in.-dia. intake, so if you discard the Y-junction with the 4-in. ports, and run a 5-in. hose closer to your machines, you’ll add efficiency.
The big motor on this collector left the chamber under my jointer very clean. You’ll need help to get this heavy unit onto its bracket, but if you’re looking for a central dust collector that won’t gobble floor space, this may be the unit for you. Strangely, this huge unit comes with the smallest plastic chip bag, but you can replace that with a taller one from Rockler.
- FDM filament printer - Printable area of 220mm by 220mm or about 8 1/2 in. by 8 1/2 in. - Great starter printer for those who aren't sure how far down the 3d printing rabbit hole they want to go.
With its graceful curves, cabriole legs, and ornamental back splat, a Queen Anne side chair is a bucket list build for many woodworkers. Dan Faia had a very specific Queen…
Become an UNLIMITED member and get it all: searchable online archive of every issue, how-to videos, Complete Illustrated Guide to Woodworking digital series, print magazine, e-newsletter, and more.
Comments
Looks like you worked really hard just to have an excuse to buy a new tool. The bench looks great! What type of wood did you use?
Log in or create an account to post a comment.
Sign up Log in