tag: layered lamination

showing 1 - 14 of 14 posts

Sort By:

Mahogany Office

fat418, member | April 29th, 2012

The office was constructed of book matched mahogany veneered plywood. The applied moldings on the doors are solid mahogany. The arched curved paneled entrance way and arched desk area are...

view details

Mickey's Wall Unit # 8

fat418, member | April 29th, 2012

The 2 upper main and 2 lower base speaker enclosures were design and built with the same details as the previous posted story, Mickey's Wall Unit # 7, explaining the construction method using the...

view details

Mickey's Wall Unit # 7

fat418, member | April 29th, 2012

The multi layered soffit was constructed using 3/8" bending plywood. The outer or face layer of the 3 layered soffit is an accustically clear, pleated silky black fabric, having a sub layer of a 1...

view details

Mickey's Wall Unit # 5

fat418, member | April 29th, 2012

The bar top was built using mdf. The bar base was built using 12 layers of 3/8" bending plywood all laminated together to make a 3" thick curved platform base to support the bar top and...

view details

Mickey's Wall Unit # 4

fat418, member | April 29th, 2012

These artistic sculpted curves were constructed using 3/8" thick bending plywood. They are basically all vertical layers that are separated by the horizontal bulk head layers to keep the curved...

view details

Mickey's Wall Unit # 3

fat418, member | April 29th, 2012

Mickey's Wall Unit post #3. This is the stereo equipment pullout system that I hand sketched out in full scale drawings, gave to the metal fabricator where I had worked hand and hand...

view details

Post #2 of Mickey's Wall Unit. My sincere apologies, descriptions and explanations will need to be edited at a later time. Looking through the pink lighted doorway is a white painted kitchen which I...

view details

Mickey's Wall Unit

fat418, member | April 29th, 20121 comment

This wall unit and bar were constructed of maple plywood for the main boxes. Bending plywood for curved flat surfaces. Mdf for the compound curved surfaces which was laminated to 3" thick in some...

view details

Maple Fireplace Wall Units

fat418, member | April 22nd, 20121 comment

The two wall units are now stained a dark mahogany and installed. After an unfortunate time delay in its shipping and its painting, the main fireplace with mantel is also now completed...

view details

Curved Motorized Maple Wall Unit

fat418, member | April 22nd, 20121 comment

This curved wall unit is constructed of maple plywood and also a bending plywood lamination for the curved doors. The interior drawer faces and drawer boxes follow the curve of the unit. The motor is...

view details

Leather Headboard

fat418, member | April 22nd, 20121 comment

This curved leather head board was constructed of ¾” maple plywood for the main frame and interior support structure. Three permanent layers of 1/8” bending plywood for the sub top...

view details

Projector Enclosure

fat418, member | March 27th, 2012

Built in 1995, this piece is made of plywood only.

view details

Mickey's Wall Unit # 1

fat418, member | March 26th, 2012

Built in 1994 using mostly MDF covered in 18K gold leaf, black lacquer, black fabric, and resin finishes. Includes fiber optics, motorization of a 4 ft by 8 ft TV lifting screen and also a...

view details

Round Motorized Bar

fat418, member | March 25th, 2012

This Bar was built using Maple and Brazilian Cherry veneer. The backing layer behind the round maple cabinet, that can be seen through the perforated holes, has a brushed aluminum finish. The...

view details

showing 1 - 14 of 14 posts