showing 1 - 20 of 45 posts
frame and panel
1 2 3 Next >
THE ADJUSTABLE CHEST By: Jim Richards
In 1970, at our first house located in Saugerties, NY, seven black cherry trees in the front yard had been struck...
Built for a wedding gift in France, made of walnut, tulipwood, pink ivory and crotch walnut inlays
This was my first Jefferson Writing Desk and major dovetail project. I think I did okay.
Blanket Box for my daughter. Walnut frame and maple panels.
Finished with shellac. Aromatic cedar inside.
I designed and builded this small tool chest specially for travelling... I intend to go to America in a wooden boatbuildind school, that is the reason why I need a light tool chest witch I can send...
Box of Philippino Toog with mobile compartment. Handcut dovetails and open slot mortise.Tung oil exterior finish, light lacquer inside.
Inspired from a James Krenov piece.
I like sliding doors and lids, partly because I get to make this nice handle in one simple step on the tablesaw.
While building a travel tool chest I had to make a hard desicion about which hand tools would make the cut. I'll tell you what I settled on, but I want to know which tools would end up in your tool chest.
I made this Pennsylvania spice box from plans published in FW #196 by Steve Latta. I modified the feet (I did not like the original flat bracket feet and thus made ogee bracket feet) and the...
I recently completed a blanket box for my daughter. This is actually the third I have made; one for each kid. It is my own “design,” if there is such a thing as designing a box. I refer...
This project was borne out of a need to replace an aging tool box used to transport R/C Airplane tools.
On the plus side it will also work well for anyone looking for a flexible tool box design. The...
I am trying to get better at joinery, but find just practicing on scrap is rather unfulfilling. I designed this box as an exercise in joinery. There is no other intended application, although I have...
This Model hapens to be half the size of my existing shop. I currently have a 24 x 40 shop/garage, but no where near the tools that I have placed in my dreamshop on here. If I ONLY had the money...
No plans were used. I just new what I wanted it to look like. Solid mahogany except for the center cubby . It has maple sides and bottom. 3 drawers each side with a tilt out on each. Bifold...
This is my attempt at making a box float. I used a similar curve as seen in my Chou Chair design. I used a nice figured Western maple. Notice how I carried the figure from the lid right downnbspto...
Well if an architect can do an aprentice pieece at 50!. I based them (one for the Mrs and one for me) on the ubiquitous design with machine cut dovetails on the drawers. Oak and Maple with oil...
I made this box for my friend's wife to house her collection of theraputic stones. The box is made primarily of walnut. The side, back panels and drawer fronts are veneered with a beautifully...
We can manufacture custom Boxes carved and uncarved, Doors, Trim, Signs, Plaques, Tabletops and Panels, Pet ash repositories.
Please e-mail me and provide any feedback you deem helpful...
Save up to 51% on Fine Woodworking
Become a Better Woodworker