Replies

1. 
   tom77 | May 06, 2007 05:24pm | #1

   There are several lift mechanisms available including woodpecker, Jessem, and Bench Dog. There are also a lot of articles and posts comparing them. A little searching should turn up a lot of material.

   But, read the article in FWW issue #189 on routers for router tables. You can buy a router designed for use in a router table for less money than one of the lift mechanisms, without the router. Think it through. I am studying the same issues, and I am probably going to buy a router capable of top adjustment and bit changing, rather than a lift mechanism.

   Best regards, Tom.

2. 
   forestgirl | May 06, 2007 05:53pm | #2

   There is a long discussion on router lifts which started recently:
   http://forums.taunton.com/fw-knots/messages?msg=35886.1

   forestgirl -- you can take the girl out of the forest, but you can't take the forest out of the girl ;-)