Replies

1. 
   GrampaMike | Jun 02, 2005 03:18pm | #1

   Go to http://www.onlinetoolreviews.com

   They have some good info here that I think will help you.

1. 
   rongoodrich1 | Jun 02, 2005 04:40pm | #2

   Thank you for the info.

2. 
   Ricks503 | Jun 10, 2005 01:28am | #10

   I found their site a bit hard to find the info I wanted1 - measure the board twice, 2 - cut it once, 3 - measure the space where it is supposed to go        4 - get a new board and go back to step 1

2. 
   WillGeorge | Jun 02, 2005 09:21pm | #3

   I have a RIDGID 6" planner and it works better en' OK!

1. 
   rongoodrich1 | Jun 02, 2005 10:12pm | #4

   Thank you - - I'll check them out.

3. 
   scott345 | Jun 02, 2005 10:29pm | #5

   I have a delta joiner, I'm not sure of model # but it's the one with the open stand. Iv'e had it for about 5 years it works fine for me.

1. 
   rongoodrich1 | Jun 07, 2005 09:13pm | #7

   Thanks for the feedback.

4. 
   scott345 | Jun 02, 2005 10:31pm | #6

   I have the dewalt surface planner the older model, it works great, I hear the newer ones are even better because of the dual speeds. I also hear that the Deltas are just as good but have no expierience with them.

1. 
   rongoodrich1 | Jun 07, 2005 09:13pm | #8

   thanks again

2. 
   rongoodrich1 | Jun 07, 2005 09:23pm | #9

   i guess they send messages twice

   so thanks ,  twice