Milling - Page 3 of 15

A Joiner’s Tool Kit
October 29, 2019

Peter Follansbee gives a glimpse into his hand-tool kit to show us what's there and why it's important.
Workshop Tip: Use a Digital Angle Cube in Place of Winding Sticks
August 22, 2019

Digital angle cube resting on top of a handplane that spans the width of a board can be an effective way to judge milling progress.
The Basics of Milling Lumber
May 30, 2019

Bob Van Dyke shares his smart machine strategy for making boards flat, straight, and square.
Reading Wood Grain–Don’t Fight the Fibers
March 19, 2019

Better ways to read grain and make the most of your lumber
How to Resaw by Hand
February 26, 2018

Sawing by hand will usually take longer than feeding the board through a bandsaw, but unless you have a massive pile to cut, it’s not so bad.
Flattening an extremely warped board on the jointer
January 10, 2017

In this video, Bob Van Dyke shows you how he flattens a board that many would consider too warped to use
Making an Octagon
December 2, 2016

This old-world layout and cutting exercise hones hand-tool skills.
Plane shopsawn veneers perfectly smooth
September 29, 2016

Bandsawing your own veneers allows you to spread a beautiful board over an entire piece of furniture. You joint one face of the board before each bandsaw cut, but the…
Tool Test: Drill Presses
July 29, 2015

Floor-standing models have more power, capacity, and convenience than benchtop models
From Lumber to Leaves
May 27, 2014

See how Greg Brown built the organic base to his tilt-top table

Page 3 of 15 Previous

1
2
3
4
5
15

Next

Most Popular

UNLIMITED membership - Get access to it all

Start Free Trial Upgrade Membership

We hope you’ve enjoyed your free articles. To keep reading, become a member today.

Get complete site access to video workshops, digital plans library, online archive, and more, plus the print magazine.