6-in. Jointer 80-150L M1 - Fine Woodworking Tool Review
  • Pin It
6-in. Jointer 80-150L M1

General - 6-in. Jointer 80-150L M1

This 6-in. jointer from General features a jackscrew system for fast knife adjustment and a built-in rabbetting ledge.

$519 (As of 10/25/2005)

Be the first to review this Tool

Editor's Review: Tool Test: 6-Inch Jointers

by William Duckworth

review date: October 25, 2005

A 6-in. jointer is a good starter size for a workshop, so I chose 11 models to examine, all of which happened to be made in either Taiwan or the People's Republic of China. The only significant differences among them were in the fence designs and the mechanisms by which you raise and lower the infeed and outfeed tables.

With a jointer, you want infeed and outfeed tables that are flat and coplanar to each other, meaning that the tables should run parallel from one end of the machine to the other.  To function properly, the surface of the outfeed table must be flush with the top arc of the knife cut and perfectly parallel to the full width of the knife cut as well as to the surface of the infeed table.

Among these machines, you can choose from four fence designs, my favorite of which is the rack-and-pinion, because adjustments are quick and easy to make, and you can move the fence in and out with one hand.

With the instructions for assembly and setup of the General International covering less than a page, the owner’s manual was written under the assumption that the buyer is mechanically adept (as most woodworkers are). The two table extensions (included) add 9-1/2 in. to the overall table length, and the tapered base with a wide footprint makes this machine more stable than most.

read full review

Editor Test Results:

Manufacturer Specifications

Manufacturer General
Manufacturer's Web Site www.general.ca
Manufacturer's Phone Number 1-888-949-1161
Horsepower 1 hp

Click on a thumbnail to see a full sized image

Become a Better Woodworker

Save up to 56% on Fine Woodworking