• PRINT
  • ADD TO FAVORITES
  • Pin It
734 Benchtop Planer

DeWalt - 734 Benchtop Planer

The DeWalt 734 has a motor rated at 15 amps and uses three 12-1/2-in. blades

$400 (As of 12/1/2007)

(2 user reviews) Write a Review

Editor's Review: Tool Test: Benchtop Thickness Planers

by Roland Johnson

review date: December 1, 2007

The DeWalt 734 has decent power and a nice, simple depth-of-cut gauge that doubles as an initial thickness indicator for easy setup. Dust collection is good. The planer leaves a good surface.

Photo: Anissa Kapsales

read full review

Editor Test Results:

Parallel Test 0.001 out of parallel
Average Snipe 0.002 infeed snipe, 0.001 outfeed snipe
Time to change knives 11:29
Knives can be sharpened No
Noise Rating N/A

Manufacturer Specifications

Manufacturer DeWalt
Manufacturer's Web Site www.dewalt.com
Manufacturer's Phone Number 800-433-9258
Extra set of knives included No
Price for Set of Knives $51.65
Reversible Knives Yes
Built-in Dust Collection No
Speed 10,000 rpm
Amps 15 amps
Maximum Thickness 6 in.
Maximum Width 12-1/2 in.
8/7/2008

I found this machine to be exactly as advertised. It does an excellent job on pine and other softwoods. It is also very good with hardwoods, just don't push it too much. Taking a small cut and longer time will yield very good surfaces either on soft or hardwood. Having a triple cutter does help with both the surface and snipe, which, incidentally, is almost non existent. Just have a good outfeed table to help especially with long boards. I would highly recommend this machine.
3/25/2008

I have found this planer to be exactly what it was advertised. It is not intended to be able to go through hardwoods at any high rate of speed. It is wise to go no more than 1/32 of an inch at a time for anything close to walnut and harder, especially if it is wider than 6 inches. Make sure and keep the drive belt clean, as it will stop drawing the wood through if the belt is not clean and you're trying to pass a hard wood through. It does however leave a very clean surface. Snipe is almost non existent, especially if you have a good outfeed table, or can have someone on the other side of the planer to "catch" boards. Dust collection is perfect, and I absolutely love the height adjustment.

Click on a thumbnail to see a full sized image

Become a Better Woodworker

Save up to 51% on Fine Woodworking