Editor's Review: Midsized Plunge Routers

by Tom Begnal

review date: October 25, 2005

Midsize plunge routers, those in the 2-hp class, have enough muscle to tackle most tasks, yet they're relatively easy to handle. Unlike a fixed-base router, a plunge router lets you lower the spinning bit straight down into a workpiece. That makes it a good choice for those who cut a lot of stopped grooves, dadoes, and mortises. So with that in mind, I gathered all eight of the midsize plunge routers on the market and gave each a thorough going-over. 

I checked to see how fussy it was to turn the machine on and off, to change router bits, and to set the plunge depth. I looked at how much finger contortion it took to set the switch locks and the plunge-lock mechanisms. I also wanted to see how well the multiple-stop systems worked. I checked the handles for comfort, then measured each router for noise, vibration, and collet runout. And after all of that, I tested each router by running it through a sheet of plywood.

The Bosch has an easy-to-activate on/off switch, a switch lock that’s almost effortless, a nice micro-adjustment knob, and a simple multiple-stop system. Optional collets are available for 3/8-in. and 8mm-shank bits. The machine did relatively well in the noise and vibration tests.

Editor Test Results: