tag: paint

showing 1 - 6 of 6 posts matching tool [X]

Sort By:

Tool Cabinets

Frank Pellow, member | September 29th, 2012

The design for one of these hanging tool cabinets can be found in the October 2006 issue of Wood magazine. Each of my two daughters has a basement workshop in a small room that is shared with a gas...

view details

Fantasy Shop

Cirick, member | October 9th, 2011

I try to line my equipment up so it can be used as an out feed table if necessary, Planer being the same height as the workbenchs etc. I have to raise the heights of some of the equipment to...

view details

ZERO CLEARENCE MITRE SAW FENCE

skex, member | April 30th, 20111 comment

A MITRE SAW FENCE SYSTEM WHICH I INVENTED ,DESIGN AND BUILD TO PREVENT OFFCUTS FLYING OFF THE BACK OF THE SAW AND TO PROVIDE BETTER SUPPORT TO THE WORK PIECE DURING THE CUT THE FENCE SYSTEM IS...

view details

Butterfly Tavern Table

PineHillPrimitives, member | May 7th, 2010

Light Figure Tiger Maple Butterfly Tavern Table. Stained with aniline Dye, Shellac, and top coat of wax.

view details

Disposable cups fit most gravity-feed spray guns

patrick_mccombe, member | July 17th, 20093 comments

Resealable plastic cups for spray guns make saving finishes and cleanup easier.

view details

A replica of the Benjamin Seaton Tool chest

wankero, member | January 28th, 20093 comments

In 2006 I decided to build a replica of the Seaton tool chest. The chest itself took about nine months working about three hours a day. Another hundred or so hours was spent making some of the...

view details

showing 1 - 6 of 6 posts