tag: chair

showing 1 - 10 of 10 posts matching dovetails [X]

Sort By:

Floating Chair

Bluecab, member | November 24th, 20112 comments

A recently completed design exploration. Maple bent laminations with walnut accents and held together with 1/2" birch dowels and marine plastic resin. Thanks' for looking!

view details

Fantasy Shop

Cirick, member | October 9th, 2011

I try to line my equipment up so it can be used as an out feed table if necessary, Planer being the same height as the workbenchs etc. I have to raise the heights of some of the equipment to...

view details

Greg Stewart's unorthodox Scottish shop.

Gregs83, member | July 20th, 2011

A very unorthodox setup for a shop none the less apart from hand tools its kind of workable in a h&s contravening haphazard way!A place to escape and create.

view details

Special Gift for "Mom"

RicksWoodCrafts, member | March 25th, 2011

This bistro set was made for my mother ( who loves cats ) for her new Ipe deck . It was yet another job I practiced many different types of joinery . I used spanish cedar and mahoganynbsp...

view details

Rietveld meets Nakashima chair

TheStebb2, member | February 21st, 20111 comment

Made out of one board of ambrosia maple, this chair was inspired by Garrit Rietveld and George Nakashima. The zig zag design originated in the 1930's, but still looks fresh today. The butterflies are...

view details

Butterfly Tavern Table

PineHillPrimitives, member | May 7th, 2010

Light Figure Tiger Maple Butterfly Tavern Table. Stained with aniline Dye, Shellac, and top coat of wax.

view details

Windsor Low Back Writing Arm

PineHillPrimitives, member | May 3rd, 20102 comments

This is a Windsor Low Back Writing Arm. I made it by splitting green Maple for the legs strechers and arm stumps. Red Oak was spit from the log to make the back spindles, and kiln dried poplar was...

view details

Oak Shop Stool

MayorGlen, member | September 9th, 20092 comments

This project began when my dad (a GREAT craftsman) and I got into a friendly discussion on how small chair legs could be and still hold you. He said that "1 inch was way too small"nbsp...

view details

Chess Table, Chairs & Chess Pieces

DennisZongker, member | February 3rd, 200910 comments

This is the first of three sets that I made. I made this set ten years ago. The other two I made seven years ago. All three sets are made out of American Black Walnut, & Hard...

view details