kiwigreg

Greg Coulter, NZ
member

Gender: Male

Birthday: 11/08/1955

Subscribe to my RSS Feed

Contributions

Simple Taper Jig

Jul 29, 2010
11 comments

This jig is designed to work with the Veritas bench clamps but other bench clamps with a 3/4" spigot would probably work. Basically it is a piece of 3/4" plywood with a bunch of 3/4" holes drilled in...


Recent comments


Re: Simple Taper Jig

Yea, but I had them anyway and use them all the time for other jigs, the drill press table and general bench clamping. Wouldn't be without them.

posted: 6:58 pm on September 5th  

Re: Simple Taper Jig

I noticed that the shaft tended to lean over when the clamp screw was tightened up, probably due to the ply being only 3/4" thick. I added the packer between the jig and the clamp to provide more support.

posted: 8:49 pm on August 29th  

Re: Simple Taper Jig

If you wanted to make repetitive cuts, you could screw a couple of scrap pieces right on to the jig to locate a side and one end.

posted: 6:19 pm on August 10th