FrankD1618


member

Subscribe to my RSS Feed

Contributions

Hickory key cabinet

Sep 30, 2009
1 comment

This is a key cabinet requested by my wife that I made from a couple of scrap doors left over from when the previous owner of our house had the cabinets installed. I cut them up and glued up some...

Cherry candle box

Mar 5, 2009
2 comments

Modification of the candle box I made in the Intro to Fine Woodworking workshop at NBSS. Slightly wider and longer, with stopped lid. Except for routing the lid and bottom grooves, all hand made from...


Recent comments


Re: Cherry candle box

Thanks, it was a great project to practice what I learned at the school. The outside dimensions are: 12 long, 6 7/8 wide, and 4 1/8 high. The width and height were set just to get the max out of the wood I had at the time. The sides are 5/8 thick; the front and rear are 1/2; the top and bottom panels are also 1/2. The panel grooves are 1/4 x 1/4. I used 1:8 for the dovetails. The pin center spacing in the rear is 1 1/4 and the front is 1 1/16. Hope this gives you enough to get started. Good luck.

posted: 9:32 pm on March 10th