Jigs

showing 1 - 6 of 6 posts matching accessory [X]

Sort By:

POWER TILTING A TABLESAW

taylorp, member | January 10th, 20112 comments

My idea is more of an adaption of existing power tools/equip. to perform the important job of tilting a Craftsman table saw arbor easily and with precision. Power tilting a table saw.If you are using...

view details

Simple Sliding Jig for Crosscut Guide

Dubliner, member | July 24th, 20106 comments

I have a quick tip you can use. It is simple to make and use, and allows multiple cuts with the crosscut fence. I have some tongue-and-groove mahogany scrap. I ripped the tongue-side of a piece and...

view details

Pencil Holder

Czappa, member | May 31st, 201011 comments

Just thought I would make a pencil holder out of a paper coffee cup. The base is Ash and the cup and base are covered in polymer resin so it will last awhile. I let the resin drip down the side to...

view details

Crosscut gauge

DanM, member | April 8th, 2010

This is very handy for cutting a number of crosscuts the same length, using the rip fence safely. The block prevents kickback. It is utterly indispensable for cutting pieces for...

view details

Golden Mean caliper

DanM, member | April 8th, 20101 comment

The openings at each end of the caliper are in the ratio of 1:1.61, an approximation to the Golden mean which is actually equal to (1 plus the square root of 5) divided by 2, or 1618039...

view details

Jointer table extensions

hammer1, member | April 4th, 20101 comment

One of the more useful accessories in my shop, extension tables for a small jointer. These make handling large, long and heavy stock a breeze. With a center mounted fence, the ends of the jointer...

view details

showing 1 - 6 of 6 posts