Reader's Gallery

Samuel's Cradle

comments (0) March 24th, 2014 in Reader's Gallery

lst1179 lst1179, member
thumbs up 6 users recommend

Samuels Cradle
Cross dowels and 3 connector bolts allow frame to be dismantled (knock down).
Instead of recommended hardboard for the basket bottom, I used 1/4 birch plywood. The lower rails and the end panels were grooved to accept the plywood. Cross pieces support the ends and middle of the plywood from the bottom as well.
Had a nice, long piece of 8/4 cherry. Matching figure when ripping and gluing up planks is always a challenge.
Lots of slats, lots of sanding, lots of mortises - but they were only 1/4 deep. Ran out of my 8/4 plank by the time I got to the rails so they are a bit lighter.
Samuels Cradle - CLICK TO ENLARGE

Samuel's Cradle


This cradle was prepared for Samuel, the first child of Joe and Rebecca, and my first grandchild. Plan is "Pendulum Cradle" from Wood Plans. Pretty much followed the plan as is, except I used mortise/tenon instead of dowel joints, and cut mortises for each slat instead of running a 1/4 groove the length of the top and bottom rails (75+ mortises!). Also, I modified the upright/trestle joint so the stand could be knocked down. It was a good plan - smooth rocking motion also. Cherry with 3 coats of danish oil. I ended up gluing some 3/4" planks together to get the 1 1/16 thickness for the stand, but it worked out well.


Design or Plan used: Pendulum Cradle

posted in: Reader's Gallery, cherry, cradle, knockdown


Comments (0)

You must be logged in to post comments. Log in.

Advertise here for as little as $50. Learn how

Save up to 51% on Fine Woodworking

 

Become a Better Woodworker