scrappy sea fish

Huck, member

18 users recommend

Add Comment
Print

What's a California carpenter to do when the chips are down, and surf is up?  When he's got too much time on his hands, and a garage full of wood scraps?  What else - build a wooden surfboard! 

Like a lot of carpenters, I tend to save more scraps than I will ever use in this lifetime.  So when I set out to build a surfboard for the first time ever, I didn't buy a chunk of foam.  Instead I rummaged through my scrap pile, and began making plans.

Redwood 2-by lumber left over from a custom gate looked like it could be shaped into rails.  Some 1/8" oak veneer plywood from a cabinet resurface looked perfect for ribs - with a little stiffening from some thin strips of cedar and a dose of I-joist technology, that is.  A cedar fenceboard run through the table saw also yielded a few planking strips, and some old redwood bender board looked handy too. 

Hey, how about this nice Honduras Mahogany from that custom entry door?  A bit heavy, but not in tiny doses.  Maybe just a little 1/4" accent strip, eh?  There we go.  And now, all these little pieces of redwood, alder, pine, poplar, whatever and what-not, bet I could piece in a fancy deck design to use them up!  OK, now it'll need some fins.  There's some beauties available, ready-made.  But why waste those perfectly good scraps of plywood?  And this closet-pole dowel looks just the right size to anchor those fin-attachment plugs!

So there it was, from scrap-pile to surf-craft.  But before I could hit the beach, I had to surf the internet for some finishing solutions.  A few very helpful forums for wood surfboard builders (one website calls 'em "a splinter group") provided the answers to help a novice fiberglasser get through the tricky process.  A simple brass screw in a threaded insert made for a low-tech pressure relief valve, in case the weather gets warm while sitting in drydock.

First time out in the surf proved the vessel a worthy seacraft, except for one performance drawback - operator error!  Other than that, I consider it the finest piece of driftwood ever to wash up on the beach, with a kook in tow!

You can see over 300 photos of this project at http://eyemagination.smugmug.com/Craftsmanship/hollow-wooden-surfboard/10118158_6wPHf#696186038_Q3gUQ

Add Comment Print

Desk name plate

Back to List

Scraptacular Gallery Challenge: Official Rules

Comments (3)

Huck writes: thanks for the comments and votes of confidence!
I'm putting it up for sale
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=140398803177
Posted: 2:27 pm on April 13th

Samuri writes: Nice job. I just entered the fur rondy woodworkers contest with a coffe table that I shaped a board for the table top. It took top honers Grew up in southern ca.and Hi.with such shapers as Dale Velzy, Dick Brewer and Randy Rarick. Sure would like to build a balsa board just like Velzy did back in the 1950's when you could surf Malibu on a six foot day with mabe 6 or seven guys in the water.
Walter in Alaska wliedke@gci.net
Posted: 12:58 pm on March 27th

larrysak3 writes: Functional art - Can't beat that.
Posted: 1:39 pm on March 10th

You must be logged in to post comments. Click here to login.