Reader's Gallery

Display Cabinet - Through Dovetails

comments (4) March 30th, 2009 in Reader's Gallery

rlafferty rlafferty, member
thumbs up 2 users recommend
Dovetails over the horizon
Glass, Bead and Brass
Books for Ballast
The Complete Picture
Dovetails over the horizon - CLICK TO ENLARGE

"Dovetails over the horizon"

Photo: Joe DeVico, the Photographic Design Group
Add CommentAdd Comment
PrintPrint

This display cabinet houses a collection of navigational sextants. It has glass doors, glass shelving, and accent lighting from above. The case, base, and door frames are clear eastern pine, the cabinet backing is bead board ply. The finish is a mix of 3 Minwax stains (Red chestnut, Early American and Dark Walnut), and 3 overcoats of Wipe on Poly.

Although a simple design, the meticulously cut through-dovetail joinery sets this cabinet project apart!

BlackpointWoodworking.com

 

 

 

 


Design or Plan used: My own design - Robert Lafferty, Blackpoint Woodworking LLC
posted in: Reader's Gallery, cabinet, dovetails, pine, bookcase, polyurethane, glass, brass
Add CommentAdd Comment PrintPrint
Back to List

Comments (4)

rlafferty rlafferty writes: One thing I forgot..............typically, I'll put at least 3 coats of poly on. Don't forget to sand in between..........very lightly, 600 grit....then wipe off with tack cloth.
Posted: 8:03 am on April 3rd

Jrussi Jrussi writes: That helps alot! I think the key might be the sponge brushes. Thanks for the tips.
Posted: 6:16 pm on April 2nd

rlafferty rlafferty writes: Thank you for the compliment!

I used minwax wipe on poly..............
Of course with a case such as this, it's easier to do flat surfaces, one by one. With the back out of the cabinet, I was able to cantileaver the case and work one surface at a time (clamp two culls on your bench and hang the case from them.)
I use sponge brushes (purchase several sizes) and work a section at a time. Dump a puddle right on the flat surface and carefully draw it along (obviously with the grain). I stay about 1/4 - 1/8" away from corners at first, then I go back and feather the poly to the edge and let that surface set up for a few minutes before rotating the case.
It all sounds tedious because it is, however, you have to be consistent in the amount you're applying, the amount of brush strokes, the duration, etc. (always have a clock in sight.)

Another tip when staining (water base, in this case): again, use sponge brushes - puddle it on liberally, draw it along, and let it sit for a few minutes. Then take a clean, lint free rag (cheese cloth works well) and use your sponge brush with very slight downward pressure onto the rag. Carefully drag them along (two handed operation) to draw off the excess stain.

Hope that helps, good luck with your next project!
Posted: 6:13 pm on April 2nd

Jrussi Jrussi writes: Beautiful work.
I recently tried wipe-on poly but certainly not with great results that you've gotten. do you have any tips? What did you use to wipe it on and what brand did you use? Thanks for any advice!
Posted: 12:35 pm on April 2nd

You must be logged in to post comments. Click here to login.