Reader's Gallery

Sculpted plywood table from scraps

comments (6) December 13th, 2013 in Reader's Gallery

Niall6319 Niall6319, member
thumbs up 20 users recommend


I made this table out of scraps of plywood and leftover veneer from an old job. The only cost I had was the time I woI had left over scraps of plywood , I cut it into squres and glued about threeeeeeuld put into making it. For the finish I used zinsser waxI made this table out of scraps of plywood and leftover veneer from an old job. The only cost I had was the time I would put into making it. For the finish I used zinsser wax free shellac. I then used liberon fine past wax and liberon 0000 steel wool.  free shellac. I then used liberon fine past wax and liberon 0000 steel wool. I made this table out of scraps of plywood and leftover veneer from an old job. The only cost I had was the time I would put into making it. For the finish I used zinsser wax free shellac. I then used liberon fine past wax and liberon 0000 steel wool. 


Design or Plan used: My own design

posted in: Reader's Gallery, table, modern, , carving, plywood, console table


Comments (6)

user-3131393 user-3131393 writes: This is beautiful Naill. I've made a couple of stools using this process after watching a video by a fellow who's name I'm sorry to say I no longer remember. It's quite stimulating watching what comes out of the muck as you go along isn't it.
Posted: 6:14 pm on February 11th

FRAATS FRAATS writes: Very nice piece, good idea !

Posted: 3:49 pm on February 5th

erik_carroll erik_carroll writes: That's pretty cool, nice work!

Posted: 6:52 pm on December 27th

Bluecab Bluecab writes: I love this! Nice work!
Posted: 1:27 pm on December 15th

TimBraatz TimBraatz writes: brilliant
Posted: 5:44 am on December 14th

Insider Insider writes: What a good idea!, this is impressive.
Posted: 6:08 pm on December 13th

You must be logged in to post comments. Log in.

Advertise here for as little as $50. Learn how

Save up to 52% on Fine Woodworking

 

Become a Better Woodworker