Tablesaw Tenon Jig

comments (5) April 1st, 2013 in Jigs

Wood-Chuck Wood-Chuck, member
thumbs up 13 users recommend

Front View
Rear View

Front View

This easy to construct jig produces accurate repeatable tenons every time. Using the same design as a full size TS sled and attaching it to your Tablesaw's Miter gauge provides an easy to use,  simple to setup jig for accurate repeatable tenons. I'm fortunate enough to have a spare miter gauge so I never have to take it apart and it's always ready to use. Bruce (Wood Chuck) 3dwoodworkingplans.com

posted in: Jigs, , tablesaw jig, Tenon Cutting Sled

Comments (5)

Denis_Solomon Denis_Solomon writes: This jig cuts the shoulders. What about the cheeks?
Posted: 7:01 pm on May 22nd

CamanoWW CamanoWW writes: If your mitre gauge is square to your blade, there is no need for this jig. Simply use a spacer against the fence to consistently get your cut the same distance from the end of your stock.
Posted: 3:40 pm on December 24th

James R James R writes: I have an old BT3000 Ryobi Table Saw that has no miter slot but does have a sliding miter table. I think this tenon jig will work just great for my saw

Posted: 9:19 pm on May 23rd

RiverRat42 RiverRat42 writes: I'm curious why you chose to use the miter gauge and not just make a bar to fit one or both miter slots on the table.
Posted: 9:33 pm on May 7th

SawDustJim SawDustJim writes: This is great: simple, easy to make, yet allows for repeatable accuracy. Clever! Thanks.
Posted: 7:59 am on April 6th

You must be logged in to post comments. Log in.

Save up to 51% on Fine Woodworking


Become a Better Woodworker