How to Sharpen a Card Scraper
Five Minute Guide: Glue-Ups
3 Steps to Great Glue-Ups: Sliding Dovetail Joints
How to Apply an Aerosol Finish
Router Jig for Perfectly Aligned Dadoes
Tablesaw Tapering Jig is Safer and Faster
Best Tabletop Finish
T-Track is a Smart Workbench Accessory
Upgrade Your Jointer with a Segmented Cutterhead
Dedicated Sled Delivers Perfect Finger Joints
How to Cut Sliding Dovetail Joints
Fixing Woodworking Mistakes
How to Make a Simple Jig for Offset Knife Hinges
Buying and Using Trim Routers
Five Minute Guide: How to Use a Tablesaw
Box Making Tips and Tricks
How to Drill Windsor Chair Mortises

Walnut Mallets

comments (0) February 3rd, 2013 in Reader's Gallery

sdbranam, member

5 users recommend

3 walnut mallets made with hand tools and the Clay beech mallet I copied, along with FW #230 containing Michael Cullen's article on making them.

Add Comment
Print

I needed 3 more mallets for hand tool classes I'll be teaching at the New England Home Show. When I saw Michael Cullen's "Make a mallet" in the Fine Woodworking "Tools and Shops" Annual Issue (Winter 2012/13 #230), I decided to follow his article.

I had some nice dense walnut scraps from a previous project, but none quite big enough for his pattern. They were big enough, however, to match my old Clay beech mallet. Since I figure a little more mass always helps, I scaled them up as big as the scraps could go.

The real challenge in making these is the tapered mortise in the head. The initial straight mortise is, ahem, straightforward, but tapering the sides to the slight odd angle is more difficult, particularly getting a consistent flat wall all the way through.

After roughing the taper with a bench chisel, I refined it with very narrow mortise chisel (so I could take small, controlled bites), narrow paring chisel, and planemaker's edge float.

Matching and fitting the taper in the handle was the intermediate challenge. On the last one, I cracked the end of the handle being too aggressive driving it in to seat it, so I had to remake it, and took more care in the fitting. Brute force never trumps careful fitting!

Design or Plan used: Michael Cullen article and existing Clay mallet.

posted in: Reader's Gallery, tool, walnut, Mallet, tapered mortise

Add Comment Print